TESTs

Egyptian Laboratories For TECHNICAL Measurement

Tests

Photometric Test

This test covers general requirements for the photometry of luminaires which are considered to be applicable to most types of luminaire.

Enclosure Protection Closses

Protected against jets of water from all directions Protected against solid bodies larger than 12 mm (eg : finger)

System Multimeter

It is taking a direct reading of voltage, current, consumer watts, the power factor of the device.

INSULATION TEST

Make sure that there is no break isolation in the event of a high voltage to 500 volts DC It uses this test complying with IEC - 598-1, paragraph 10.2.1.

EARTH TEST

Make sure that the resistance is not more than 0.5 between any metal part of the unit and ground party shall comply with IEC - 598-1

LEAKAGE CURENT TEST

The leakage current that may occur during normal operation of the luminaire between each pole of the supply source and the body of the luminaire.

HIGH VOLTAGE TEST

Make sure that there is no break isolation in the event of a high voltage to 1500 volts DC. It uses this test complying with IEC - 598-1, paragraph 10.2.2